Fender Roll help in INDY, CINCY or Louisville!!!

[smac2K]

After the installation of my swift springs, my car is rubbing on the rears REAL bad

I am willing to travel to Cincy, Louisville or somewhere within 2 or so hours from INDY...

Apparently my offset is enough that I am destroying my tires and making this awful noise :LOL: anytime I hit a dip or take a turn and a steady speed...

Thanks for your help...

[Coop]

and your running the euro spec on the alignment ?

[smac2K]

[DaveL]

NP - I looked and I've still got a baseball bat in the garage ... bring it on ... I've even got the sand bags and jacks!!!!

[batguano]

Rolling may be needed but before you go to that extreme, try this.

There is a tab that extends out on the wheel well that causes most of the problem.
It is just aft of the center point of the well opening. Run your hand on the edge of the well toward the back and you will feel it.
Get a die grinder or roto tool and grind that tab down. before you do however, drill a hole bout 2 inches behind the tab and use either a screw or rivet to secure the liner.

I had to do this and it cleared my rubbing problems.

Good luck.

[pezjunki]

I know a bunch of shops in Louisville does it, but I don't have personal experience with any of them..

[kevos2k]

ive got a fender roller J, you pay shipping both ways and you can use it its not that hard

[smac2K]

ive got a fender roller J, you pay shipping both ways and you can use it its not that hard

Does it come with instructions? How heavy is it?

[kevos2k]

ya i have some instructions and a heat guy... sent it to texas before it was like $20 each way maybe a little less